Aqua Medic DC Runner 2.3

Aqua Medic DC Runner 2.3
+ for use as a circulation or current pump in salt or freshwater aquaria
+ incl. Controller for adjusting the water output
+ 0-10 V-connection for external control
+ control and programming via App (iTunes and Google Playstore) or manually via the controller
+ ULTRA SILENT due to optimized control electronics
+ rugged pump housing
+ power-saving D/C motor 24 Volt, high efficiency
+ polished ceramic shaft and bearings for quiet operation and low maintenance
+ submerged and non-submerged use is possible

technical Data Aqua Medic DC Runner 2.3:
transparency pump housing
0-10 V connection for external control
Pump output: up to 2000 l/h
max. pump height: 2.2 m
max. Power consumption: 20 W
Power supply pump: 24 V
Power supply transformer: 110-240 V/50-60 Hz
Connector suction side: 25 mm
Connector pressure side: 25 mm
Protection rating: IPX8
Dimensions incl. basket: 140x68x100 mm
Dimensions without basket: 105x68x100 mm
suitable for fresh and marine water
can be installed fully submerged or out of water

The Aqua Medic DC Runner 2.3 is a powerful universal pump for use in fresh and marine water aquaria. The Aqua Medic DC Runner is a magnetically coupled current pump and have a fully encapsulated synchronous motor. All materials are salt-water resistant. The pump is operated at 24 V DC safety voltage, with the transformer included. The Aqua Medic DC Runner 2.3 is controlled via Aqua Medic DC Runner Controller which allows for running a variety of different levels. In addition to control via controller, control via app with smartphone or tablet is possible. The Aqua Medic DC Runner pump is suitable for installation under water and out of water.

Aqua Medic DC Runner Controller The included DC Runner Controller is switched between power supply and pump to adjust the output. The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press the button -FEED-, the output will stop for 10 minutes. There is an automatic shut off if there is no water for 2 minutes. An extension cable with 1.80 m in the length is optionally available. With this cable you can extend the cable between pump and controller.